Choice
Input = 2 = Offset
Input = 2 = Offset
Input = 16 exe
Input = 12 exe
Input = 14 exe
Choice
Input = 2 = Outside Dia.
Input = 2 = Outside Dia.
Input = .0625 exe
Input = 12 exe
Take Note of Dimension
Best to HOLD Decimal Dim
Best to HOLD Decimal Dim
Input = 5 exe
Input = 16 exe
NOTE!
Take Note of Dimension
Input = 6 exe
Input = 2 exe
Sample INPUT Dimensions for
OFFSET Square to Round Flat Pattern
OFFSET Square to Round Flat Pattern
This is one of the more complicated Layouts, and has quite a few more Variable Inputs compaired to most of the Layout Programs. To the left are the actual Calculator Input Screens for the Square to Round. They run LEFT to RIGHT. If you look at the Input Dimensions below the Input screens to the left, and look where the dimensions are located from the drawing shown above. The 1st screen is giving you a choice of a (1) Center-Line or a (2) Offset Square to Round, we picked the toughest, #2 Offset. Pay close attention to what it's asking you, like Inside, Outside, Length, Width, and QUAD # then look at the drawing.
As fast as you can punch in these numbers in and hit the blue EXE key, it will then be Layed-Out and waiting for you to start the Lay-Out process . Click HERE to see this process.
As fast as you can punch in these numbers in and hit the blue EXE key, it will then be Layed-Out and waiting for you to start the Lay-Out process . Click HERE to see this process.
All these Inputs have to be known no matter how you lay it out, whether by hand or computer.